Dave Smith Instruments Evolver Manuel d'utilisateur télécharger pdf (Page 22)

Level: 0…100 – Sets the volume of the selected Oscillator.

Glide: Normal 0…100; Finger 02…Finger 100; Keybd Off – Sets the Oscillator

Glide rate. Glide can be set independently for each oscillator. Low settings are faster.

Normal Glide covers the range from 1 to 100 (0 is no glide). A “fingered” mode that

only glides when more than one note is held down is selected by setting glide over

100, where it ranges from Finger 02 to Finger 100 (equivalent to glides of 2 to 100).

Note: If you set glide all the way to maximum, it goes to Keybd Off, which has the

effect of disconnecting the selected oscillator from the keyboard.

Sync 2-> 1 – When enabled (lit), turns oscillator hard sync on. With sync on,

whenever oscillator 2 resets, it will also reset oscillator 1 for the classic hard sync

sound.

Oscillators 3 and 4

Oscillators 3 and 4 are digital waveshape oscillators. Oscillator 3 is hardwired to the

Left channel; Oscillator 4 is hardwired to the Right channel. Like the original Prophet

VS, the digital oscillators in Evolvers get quite trashy at higher frequencies.

Frequency: C -2…C 8 – Selects base frequency over a 10 octave range, from 8 Hz

to 8kHz, stepping in semitones. C3 is middle C, the first octave is -2 (C-2, C#-2, and

so on), the second octave is -1 (C-1, C#-1, and so on), the third is zero (C 0, C# 0…),

and so on.

Fine: -50…+50 – Fine Tune control; 0 centered. Steps in cents (50 cents = ½

semitone).

Shape/PW: 1…128 – Selects a digital waveshape. Waveshapes 1 - 95 correspond to

ROM (preset) Waveshapes 32 - 126 in the Prophet-VS. Waveshapes 97 - 128 are

user programmable via the software editor. In the VS, the user waves were 0 - 31,

and wave 127 was noise, which is not included because the Evolver has a separate

noise generator. Wave 96 has a Waveshape that is unique to Evolver in place of the

VS noise. Wave 95 (126 on the VS) is a “blank” wave, which can give some options

while sequencing waves. The Evolver ships with waves 97 - 128 the same as 1 - 32.

Level: 0…100 – Sets the volume of the selected Oscillator.

Glide: Normal 0…100; Finger 02…Finger 100; Keybd Off – Sets the oscillator

Glide rate. Glide can be set independently for each oscillator. Low settings are faster.

Normal Glide covers the range from 1 to 100 (0 is no glide). A “fingered” mode that

only glides when more than one note is held down is selected by setting glide over

100, where it ranges from Finger 02 to Finger 100 (equivalent to glides of 2 to 100).

Note: If you set glide all the way to maximum, it goes to Keybd Off, which has the

effect of disconnecting the selected oscillator from keyboard.

FM: 0…100 – Sets the amount of Frequency Modulation. If Oscillator 3 is selected,

FM is applied to Oscillator 3 from Oscillator 4. If Oscillator 4 is selected, FM is applied

to Oscillator 4 from Oscillator 3. Note that each digital oscillator can FM the other at

the same time for some wild results.

Ring Mod: 0…100 – Sets the amount of Ring (Amplitude) Modulation. If Oscillator 3

is selected, Ring Modulation is applied to Oscillator 3 from Oscillator 4. If Oscillator 4

is selected, Ring Modulation is applied to Oscillator 4 from Oscillator 3. Note that each

digital oscillator can Ring modulate the other at the same time.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

Dave Smith Instruments Evolver Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Pianos numériques Dave Smith Instruments Evolver