Dave Smith Instruments Mopho Keyboard Spécifications télécharger pdf (Page 27)

Env Delay: 0…127 — Sets a delay between the time Envelope 3 is triggered and

when the Attack portion actually begins.

Env Attack: 0…127 — Sets the Attack time of Envelope 3.

Env Decay: 0…127 — Sets the Decay time.

Env Sustain: 0…127 — Sets the Sustain level.

Env Release: 0…127 — Sets the Release time.

Repeat: Off, On — When on, causes the delay, attack, decay, and sustain

portions of Envelope 3 to loop for as long as the envelope is gated on.

Modulation Parameters

The Modulation Parameters let you configure the modulation routing and

amount for Mopho’s four general-purpose modulation slots as well as for MIDI

controllers (Mod Wheel, Key Pressure, Breath Control, Velocity, and Foot

Controller).

Since each Mopho mod source has a single destination, the four general purpose

Mods provide a way to send a mod source (such as a sequence or LFO) to

additional destinations, with a different amount. There are also additional mod

sources available here, such as Noise, allowing a wide variety of possibilities.

To configure a general-purpose modulation slot, select the appropriate

modulator (Mod 1, Mod 2, Mod 3, or Mod 4), and use the Source, Destination,

and Amount parameters to route the modulation as desired.

To configure modulation for a standard MIDI controller, select the desired

controller and amount, and then set the destination.

Source — Selects a modulation source. See Modulation Sources on page 28 for

possible sources.

Amount: -127…+127 — Sets the amount of modulation.

Destination — Selects a modulation destination. See Modulation Destinations

on page 26 for a list of possible destinations.

Mod Wheel Amount: -127…+127 — Sets the maximum amount of modulation

that can be applied from MIDI Continuous Controller 1 (mod wheel).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Pas de commentaire

Dave Smith Instruments Mopho Keyboard Spécifications Page 27