Dave Smith Instruments Evolver Manuel d'utilisateur télécharger pdf (Page 34)

Destination 1: see table – Selects a modulation destination. See the Modulation

Destination table on page 41 for a list of possible destinations.

Misc Parameters

The Misc Parameters section lets you configure a variety of parameters not found

elsewhere. The parameter list is printed on the panel as seen above.

Trigger Select: see table – Selects the source of triggers/gates for the envelope

generators. In the Poly (different from the Evolver) some of the Trigger modes will

automatically turn the Sequencer on. This allows gated-sequence Programs to be

played without having to manually hit the S

TART/STOP switch. The Trigger modes that

do this are marked in the table as AUTO.

Display Envelope Trigger Selections

Sequencer or Key

The envelopes will be triggered by either the

sequencer or the keyboard. When triggered by the

sequencer, the gates are on for half the step time.

Simply adjust the envelope parameters (ADSR) for the

desired effect.

Sequencer Only

The envelopes will be triggered by only the sequencer.

Keyboard Only

The envelopes will be triggered by the keyboard only.

Key, Resets Seq

The envelopes will be triggered by the keyboard, and

the sequencer will be reset on every key (if it is

running). The sequencer will not trigger the envelopes.

Key, Gates Seq

Gated mode – the envelopes will be triggered by the

sequencer when a key is held; in other words the

keyboard will gate the sequencer. AUTO

KeyGates Seq Rst

Gated mode, reset – same as Gated mode, except

every time a key is hit, the sequencer is reset to step

1. AUTO

Ext Audio Input

The envelopes are gated by the Left external audio

input signal level, in other words, when the signal gets

above a fixed threshold, the envelopes start. The

envelopes then go into the release phase when the

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

Pas de commentaire

Dave Smith Instruments Evolver Manuel d'utilisateur Page 34